¶ Compatibility
This guide applies to the following machine. Please note when referencing:
Machine model: U1
¶ Installation Location
¶ Quick Overview
Replacement Difficulty: ★★☆☆☆ (Easy)
Estimated Time: 20 minutes
¶ Preparation
¶ Procedure
¶ Part 1 - Removing the Top Cover
(1) Disconnect the top cover cable and remove the magnetic front door.
(2) Remove the top cover from the printer.
(3) Open the filter cover and remove the filter.
(4) Turn the top cover over and unlock the clips in the direction shown in the illustration.
¶ Part 2 - Removing the Internal Circulation Kit
(1) Use the H2.0 hex key to remove the 3 screws securing the internal circulation kit.
(2) Turn the upper housing upside down and use the H2.0 hex key to remove the 2 screws securing the adapter board.
¶ Part 3 - Removing and Installing the Recirculation Fan
(1) Use the H2.0 hex key to remove the 3 screws securing the filter box.
(2) Remove the filter box and separate the fan from the base.
(3) Install the fan and route the fan cable through the opening.
¶ Part 4 - Installing the Internal Circulation Kit
(1) Align the filter box with the blower mounting base using the locating pins, and use the H2.0 hex key to tighten the 3 securing screws.
(2) Place the internal circulation kit in the corresponding position, use the H2.0 hex key to tighten the screws securing the internal circulation kit, and install the filter.
(3) Install the adapter board and connect the cables.
(4) Use the H2.0 hex key to tighten the screws securing the adapter board.
¶ Part 5 - Installing the Top Cover
Refer to the Top Cover User Manual for installation: Top Cover User Guides
¶ Endnote
If your issue remains unresolved, please contact technical support, our dedicated support team will be more than willing to assist you in resolving the issue.
If you have any suggestions or feedback about this wiki, feel free to leave a comment below. Every piece of feedback helps us improve our documentation.